EXPERTISE / CONCRETE REPAIR

Concrete repair in Tunisia: bridges, buildings and industrial sites

BBTP restores damaged concrete on bridges, viaducts and culverts: removing damaged concrete, treating corroded reinforcement, rebuilding and protecting the surfaces, including in marine settings and at height.

HOW IT WORKS

Why does bridge concrete deteriorate?

Reinforcement is protected by the alkalinity of the concrete cover. Carbonation of that cover, or chloride ingress in marine settings, depassivates the steel and it corrodes. The expansive corrosion products spall the concrete cover and expose the bars.

Add to this cracking, water leaking through failed joints or waterproofing, and impacts. Early repair limits the loss of steel section and the spread of the damage.

DIAGNOSIS

The defects we treat.

They are most often found on pier caps, bearing plinths, beam ends and soffits, piers and deck edges.

  • Spalled concrete, exposed reinforcement
  • Rust stains and streaks on the surfaces
  • Cracks, with or without water seepage
  • Chipped edges and broken corners
  • Damaged plinths and bearing areas

TECHNIQUES

The right answer for each defect.

Depending on the diagnosis, several techniques are combined. When the structure lacks capacity, the repair goes with strengthening.

01

Repair mortars

Shrinkage-compensated repair mortars (EN 1504-3), hand-applied or cast in formwork, to rebuild the concrete and restore the cover to the steel.

02

Crack injection

Crack injection with epoxy resin or grout, depending on crack width and activity, to restore the watertightness and integrity of the concrete.

03

Surface protection

Protective coatings (water-repellent, anti-carbonation) that limit the ingress of water, CO₂ and chlorides, as on the Sidi Abdelhamid bridges in Sousse.

OUR METHOD

Repair in five steps.

  1. Assessment

    Hammer sounding and joint survey of the areas to treat, based on the structure’s assessment.

  2. Breaking out

    Breaking out damaged concrete back to sound concrete and exposing the bars all round.

  3. Treating the reinforcement

    Wire-brushing or blasting the steel and applying a passivating primer; additional bars where the loss of section requires it.

  4. Rebuilding

    Rebuilding with repair mortar or micro-concrete on a pre-wetted substrate, then resurfacing.

  5. Protection

    Protective coating on repaired faces and exposed areas.

DIFFICULT SITES

Above water, at height, by the sea.

Much of the repair work is done under the deck, far from the ground. BBTP works from scaffolding fixed to the piers, suspended scaffolding and platforms, by day and by night.

  • Scaffolding fixed to the piers, above the Bizerte channel.
  • Scaffolding under the deck, above the Medjerda river.
  • Suspended platforms for high sections.
  • Concrete in marine settings, exposed to salt.

ON SITE

Before, during and after: our repairs.

All photos ↗

WHY BBTP

Why entrust your repairs to BBTP?

01

A speciality

BBTP specialises in repairing bridges and strengthening concrete structures.

02

Field experience

Work in all 24 Tunisian governorates, notably for the Ministry of Equipment.

03

Passed-on know-how

Crews trained by Mohamed Salah Biri, former head of SOMATRA’s structures department.

FAQ

Concrete repair: your questions.

Do you also work on buildings?

Yes. Beyond bridges and structures, BBTP repairs and strengthens buildings: residential and public buildings, factories, cement plants and industrial sites, with the same techniques.

What does breaking out concrete mean?

It means removing damaged concrete with a light breaker back to sound concrete, exposing the bars all round so they can be treated.

Why does reinforcement corrode inside concrete?

Sound concrete protects the steel through its alkalinity. When the carbonation front or chlorides reach the bars, they corrode; the expansive corrosion products spall the concrete cover.

Is a crack always serious?

No. Many fine cracks are harmless to the structure, but they let water in. The assessment separates those that only need monitoring or sealing from those that point to a structural problem.

Does the structure have to be closed during repairs?

Not necessarily: most repairs are done from scaffolding or platforms under the deck. Traffic arrangements are agreed with the project owner; when a bearing area must be relieved, the deck is jacked.

Where do you work?

Throughout Tunisia. BBTP works in all 24 governorates, notably for the Ministry of Equipment.

A STRUCTURE TO REPAIR?

Let’s talk about your structure.

Project owners, design offices, contractors: tell us about the structure and the defects observed, and we will get back to you.

Contact us